![]() A gentle "smile" is often the best setting for any graphic eq device if you are trying to actually boost the bass and treble. ![]() It is best to cut back on the eq which will provide a similar effect to boosting the eq when done correctly. Too much bass or treble boost can easily overdrive your loudspeakers and result in poor sound quality, at the least, and destroyed drivers all too often. Distorted inputs lead to distorted outputs. The amp has its limits and the receiver's low Voltage circuitry can be overdriven by excessive Voltage coming from the eq.Ĭonsumer grade eq's are traditionally very cheaply made and their circuits can quite easily be overdriven with excessive boost leading to a distorted signal being sent back to the receiver. In other words, eq adjustments should be made with as little boost as possible. To exclude the eq you disengage the monitor.ĭo not use the eq as a volume control. To engage the eq in the audio signal path, you engage the tape monitor if you've taken the connection from the tape monitor side. Use only one circuit, either tape or line and don't mix those two. Just always think in to out and out to in. If you take the eq input from the tape monitor, you must take the eq output to the receiver's tape input. You'll only have one choice left after you make that connection. Tape/line out from the receiver goes to tape/line input on the eq. Therefore, in goes to out and out goes to in no matter which device you are looking at. Read the archives for more answers to your question.īasically, each device acts as its own entity. The topic has been covered extensively throughout this forum section.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |